Gracias a webs como Bricomanía-Hogarutil.com, de donde hemos cogido prestadas las imágenes y los consejos, disponemos de tutoriales de instalación que nos guían paso a paso para instalar correctamente pomos y tiradores integrados en armarios. El proceso no es complicado pero es necesario no saltarse ninguna etapa.
Paso 1: Elegir el tirador que mejor encaje con el mueble.
Paso 2: Antes de realizar el orificio, asegurarnos de que la puerta tiene el grosor suficiente para albergar el nuevo accesorio.
Paso 3: Retirar el pomo antiguo y marcar en la puerta el punto central del nuevo tirador.
Paso 4: Acoplar a nuestro taladro una broca fresa del mismo diámetro que el accesorio. Para que el alojamiento tenga la profundidad deseada, poner, como referencia, cinta adhesiva en la base de la fresa.
Paso 5: Realizar el rebaje en la puerta del mueble.
Paso 6: Comprobar que el tirador encaja perfectamente y aplicar adhesivo de montaje en la parte posterior de la pieza metálica.
Paso 7: Encastrar el tirador en su posición y hacer lo mismo en el resto de puertas o cajones.
Paso 8: Una vez que el producto se haya secado, rematar el trabajo cubriendo los viejos agujeros (si es necesario) con embellecedores autoadhesivos.
Aquí puedes ver el vídeo.
Thanks to sites like Bricomanía-Hogarutil.com, from which we take images and advice, we have installation tutorials that guide us step by step to install properly integrated handles and knobs. The process is not complicated but you need not skip any step.
Step 1: Choose the handle that best fits with the furniture.
Step 2: Before making the hole, make sure that the door is of sufficient thickness to accommodate the new accessory.
Step 3: Remove the old handle and mark the centre point of the new handle on the door.
Step 4: Fit a new bit to the drill with the same diameter as the accessory. So the hole has the desired depth, place a piece of tape at the base of the drill-bit as a reference.
Step 5: Make the cut on the door of the furniture.
Step 6: Check that the handle fits perfectly and apply assembly adhesive to the rear part of the metallic piece.
Step 7: Fix the handle in its position and do the same with the rest of the doors or drawers.
Step 8: Once the product has dried, finish of the task by covering the old holes (if necessary) with auto adhesive trimming.
Here you can see the video.